Setup:Installation Guide/Optimization/Caching

This document describes different caching options to enhance the performance of your BlueSpice installation.

Tips for the Document

• Please, read this manual completely and work through the single installation steps one after another.
• For editing the configuration files with a text editor, the files must be saved in UTF-8 coding without BOM (Byte Order Mark).
• The placeholder <installpath-bluespice> stands for the path to your BlueSpice installation, e.g C:\inetpub\wwwroot\bluespice (Windows) or /var/www/bluespice (Linux).

Linux vs. Windows

Please note that with equal hardware conditions, BlueSpice empirically runs more performantly on Linux than on Windows servers.

Indicate Cache-Directory

This forces BlueSpice to use the filesystem instead of the database for some internal caches. To do this, create the file <installpath-bluespice>/settings.d/001-Directories.php and add the following content:

<?php

$wgCacheDirectory = "$IP/cache";

Save and close the file.

Hinweis:The directory "cache" in <installpath-bluespice> must be writable by the web server. For more information, read the file system permissions.

Name Resolution of the Database

If this hasn't already been done while setting up MediaWiki, please make sure that the database server will be adressed via IP if it runs on the same server than BlueSpice. Especially Windows has problems with the resolution of "localhost".

To do this, open <installpath-bluespice>/LocalSettings.php and locate the variable $wgDBserver. The line should ideally be:

$wgDBserver = "127.0.0.1";

Activate Memcached

Create the file <installpath-bluespice>/settings.d/001-Memcached.php and add the following content:

<?php

$wgMainCacheType = CACHE_MEMCACHED;
$wgSessionCacheType = CACHE_DB;
$wgMemCachedServers = [ "127.0.0.1:11211" ];

Save and close the file.

Hinweis:The prerequisite is an installed and configured memcached server on the BlueSpice server. Read the memcached article for more information.

Increase PHP Memory Limit

A higher memory limit of PHP results in a faster execution. ¶ This can be changed in php.ini. Locate and adjust the following option:

memory_limit = 512M (means 512 MB - varies from the available memory)

After saving and closing php.ini, the web server must be restarted.

Activate Bytecode Cache in PHP

Since PHP 5.5 the bytecode cache "opcache" is included.

This needs to be activated in the php.ini first. Check if the module is integrated there. This is done via the line:

zend_extension=opcache.dll (Windows)
zend_extension=opcache.so (Linux)

Hinweis:Please also note the specification of the distributor for activating PHP modules under Linux.

Please, do the following configuration of the opcache in php.ini. Normally, all options should already exist, but are commented out by semicolon (;) at the beginning of the line. Locate the respective option in php.ini, remove the semicolon at the beginning of the line and adjust the settings as follows:

opcache.enable=1
opcache.memory_consumption=512 (means 512 MB - varies from the available memory)
opcache.max_accelerated_files=5000
opcache.validate_timestamps=1
opcache.revalidate_freq=2

After saving and closing php.ini, the web server must be restarted.

Deactivate JobQueue

For this, read the paragraph "runJobs.php" in the "Cronjobs" article.

---

To submit feedback about this documentation, visit our community forum.